1. Close all doors & windows. If secure, keypad displays "SYSTEM READY". If not see "Bypassing A Zone" (below).
2. If Leaving House, Press 9
   If staying Home, Press 0
3. Enter your Code. Bypass any zone here.
4. You have 40 seconds to exit.

Bypassing A Zone When Arming

If, when arming the system, a zone is open you can bypass that zone by pressing asterisk (*) followed by the zone number button on the keypad followed by another asterisk (*).

Turning OFF The Alarm

If the system is on when you enter, the buzzer on the keypad will sound.

1. Enter Code.

Power Failure Or System Trouble

An on-off warble tone will sound, and the display will show Press 4 to View.

1. Press 4.
2. The display will tell you what the
   trouble or problem is.
3. Press CLEAR to silence.
4. Call Denalect Alarm, but wait 15 minutes if it is an AC power failure.

1. Enter your Code to silence the bell.
2. Check each smoke detector to see which has a lamp on, and also check the heat sensors.
3. Press 3.
4. Enter your Code to reset the system.

If the BELL is Ringing

1. Enter your Code.
2. Wait 30 seconds, then call Denalect Alarm at 925-935-2680.

Programming User Codes

1. Press the 6 button.
2. Enter the master code.
3. Press 0.
4. Enter the user number of the code you want to program. 1–6 (8 for the duress code)
5. Enter the new Code.
6. Enter the code again.
7. Press CLEAR twice.
8. Test the new code.