1. Close all doors & windows. All Zone Lamps will be out.
   If any zone lamps are blinking, see Bypassing A Zone (below).
2. If Leaving House, Press 9
   If staying Home, Press 0
3. Enter your Code.
4. Bypass any open zones here.

Bypassing A Zone When Arming

If, when arming the system, a zone lamp blinks showing something is open, you can bypass that zone by entering the zone number button on the keypad

Turning OFF The Alarm

If the system is on when you enter, the buzzer on the keypad will sound.

1. Enter Code.

Power Failure Or System Trouble

An on-off warble tone will sound, and the OK lamp will blink.

1. Press 4.
2. The lighted Zone Lamp means:
   Zone 1, 2 = Zone Trouble
   Zone 3 = AC Power Failure
   Zone 4, 5 = Phone line or other trouble
   
3. Press CLEAR to silence.
4. Call Denalect Alarm, but wait 15 minutes if it is an AC power failure.

1. Enter your Code to silence the bell.
2. Check each smoke detector to see which has a lamp on, and also check the heat sensors.
3. Press 3.
4. Enter your Code to reset the system.

If the BELL is Ringing

1. Enter your Code.
2. Wait 30 seconds, then call Denalect Alarm at 925-935-2680.

Programming User Codes

1. Press the 6 button.
2. Enter the master code.
3. Press 0.
4. Enter the user number of the code you want to program. 1–6 (8 for the duress code)
5. Enter the new Code.
6. Enter the code again.
7. Press CLEAR twice.
8. Test the new code.